The adsorption behavior of2-Hydroxybenzal-rhodanine ( 2-HBR) loaded resin for Pd is discussed. 本文探讨了2-羟基苄叉罗丹宁(2-HBR)负载树脂对钯的吸附特性及其分析应用。
PTC effect in carbon black/ silica loaded epoxy resin 炭黑/二氧化硅/环氧树脂基复合材料的PTC效应
A method of micro-column separation-ICP-MS determination of trace Dy, Ho, Er, Tm in high purity Sm_2O_3 was studied. By adopting Cyanex 272 loaded resin column and optimizing separation conditions for separating Sm matrix, the separation period was only 32 min. 研究了微柱分离ICPMS测定高纯氧化钐中痕量Dy,Ho,Er,Tm的方法,方法基于采用Cyanex272负载树脂微柱,选定上述杂质与大量基体分离的实验条件,分离周期为32min。
Analytical Characteristics of Zincon Loaded Resin and Its Application 锌试剂负载树脂的分析特性及其应用
In this paper, Fe(ⅲ)-loaded chelating resin was prepared and the research was focused on the adsorption of arsenic(ⅴ) by Fe(ⅲ)-loaded chelating resin. 本文制备了Fe(Ⅲ)负载型螯合树脂并对其吸附砷(Ⅴ)进行了研究。
Absorption Performance of Lead on Fibriform Diphenylthiocarbazone Loaded Polyamide Resin 纤维状负载双硫腙聚酰胺树脂对铅的吸附性能
Compared with the non loaded ion exchange resin, the conversion increased 17.32% on the same condition. 比没有进行负载处理的离子交换树脂,在同样的条件下酯的转化率提高17.32个百分点。
The readsorption investigation of uranium loaded resin was also discussed in this chapter. 此外,还进行了载铀树脂再吸附工艺的研究。
Study on regularity of desorption of gold loaded resin 载金树脂硫脲硫酸解吸规律的研究
Application of loaded resin readsorption process in Yining Uranium Mine 负载树脂饱和再吸附工艺的生产实践
Recovery of uranium from loaded resin of processing in-situ leaching solution by alkaline elution system 采用碱性解吸系统从加工地浸液的饱和树脂中回收铀
The influence factors which affected the activity of catalyst, such as amount of metal salt, loaded temperature, loaded time, granule size of carrier were studied by using uniform design and ion exchange resin as carrier. 以离子交换树脂为载体,用均匀设计方法考查了负载型酯化催化剂制备中负载金属盐用量,负载温度,负载时间和载体粒度等因素对催化剂活性的影响。
When nickel foam surface was entirely covered with Ru, i.e. 6%, the catalyst became the most effective on decomposition of NaBH_4. Comparing with the catalyst loaded on the ion exchanged resin beads, Ru loaded nickel foam was more stable and safer. 当泡沫镍表面完全被钌覆盖时,载钌量为6%,相应的催化能力最强。与离子交换树脂载钌催化剂相比,泡沫镍载钌催化剂更稳定、耐用。
The loaded resin is backflushed with water, eluted with acid, regenerated with base, washed with water, and then returned to the adsorption column. 饱和树脂在专门设计的填充塔内进行水反冲洗、酸淋洗、碱再生以及水洗等处理后再返回吸附塔。
The processes of cyanide desorbing and recovery from loaded 201 × 7 resin by alkali and sulfuric acid solution under the ultrasonic affection are investigated. 研究超声波作用下碱液和硫酸溶液解吸负载氰化物的201×7树脂回收氰化物的工艺过程。
It is shown in this paper that uranium and molybdenum can be simultaneously eluted from uranium and molybdenum loaded resin using eluant ( NH4) 2CO3+ ( NH4) 2SO4.The ADU is precipitated from eluat by volatilization of ammonia. 用(NH4)2CO3-(NH4)2SO4解吸剂可以从含铀、钼树脂上同时解吸铀和钼。解吸液经蒸氨沉淀ADU。
As a new production technique of yellow cake, resorption with loaded resin elution with acid ammonium nitrate precipitation in two steps is studied. 研究了负载树脂再吸附-酸性硝酸铵淋洗-二步沉淀生产重铀酸盐的新工艺。
Study on Adsorption Properties of Silver Ion on Theophylline Loaded Resin with ICP AES 用ICP-AES研究茶碱负载树脂对银离子的吸附行为
The synthesis of loaded resin containing nitroso R salt as chelating group is reported in this paper. 以亚硝基R盐作为螯合剂制备了负载树脂,研究了用该树脂分离富集Au(Ⅲ)、Pt(Ⅳ)和Pd(Ⅱ)的最佳条件。
Ion exchange resin recovery of gold from thiosulfate leaching solution has been investigated. The suitable ion exchange resin and proper process conditions which content gold adsorption and gold desorption from loaded gold resin were tested. 采用离子交换树脂法进行了硫代硫酸盐浸金液中金的回收研究,通过试验研究和理论分析,优选出了适宜的离子交换树脂和金吸附及载金树脂金洗脱工艺条件。
Intermediate crack debonding, strain distribution and slip at the loaded end in FRP plate or resin layers corresponding to the experimental load also are defined. 根据实验荷载也确定了在加载结束后,FRP板或者树脂板层上的中间开裂脱粘、应变分布和滑移。